Converting your side marker into turn signals. Works on all Kappa's

Cut back insulation going to the side marker to expost the two wires, pull out the black wire and clip it as far away from the side marker as possible. This will give you room for the wire to reach the other harness.

Cut off/remove all the electrical tape going to the plug to expose the 4 wires.  I used a wire stripper on the blue wire to slide the insulation back a tiny bit and stripped the end of the black wire.  I then wrapped the black wire exposed end around the stripped section of the blue wire.  Soldered the joint and tapped everything back up.  It looks factory but has a much better safety feature.

Enjoy!